Presta-only valve core remover.
I finally got around to fixing the original issue thanks to a make by user cmh. I already knew it didn't work - but got lazy & never fixed it.
I referenced:
Which are CADs done by Jared over at GrabCAD.
Referenced the Stan's tool only for general body dimensions.
I tried using my chain tool off a Topeak Ratchet Rocket on a removable valve core, & it works as claimed.
I took this measurement (4.1 mm across the flats) & remade that in my SLDPRT model.
Most other dimensions are non-critical to the function, so I left them as is.
Update 7 Aug 18: I added 3 more STLs. In total, they cover the spectrum of 8, 10, 11, & 12 mm ODs on the interface head. Hopefully this will address strength problems.
All other sections are hereby obsolete.
| Dimensions_OBSOLETE.SLDPRT | 73.2KB | |
| Presta_valve_core_remover.STL | 283.2KB | |
| Presta_valve_core_remover_10.STL | 257.4KB | |
| Presta_valve_core_remover_11.STL | 290.0KB | |
| Presta_valve_core_remover_12.STL | 315.6KB | |
| Valve_Core_Remover_OBSOLETE.SLDPRT | 177.3KB | |
| Valve_Core_Remover_OBSOLETE.STL | 279.4KB |
