Nothing should require supports.
Put together using hot glue gun.
I curled the sepals by pressing the them against a hot part of my hot glue gun together for a few seconds, then curling them by hand or with tweezers once the petal became pliable,.
Curl them in any direction and blow on it to cool it down.
Arrangement in the picture.
Suggestions:
If you can edit the FreeCAD files. I suggest printing 4 stems that are about 20mm longer so the middle flowers are taller than the ones on the side.
Rose Flower by Thinkinglink
https://www.thingiverse.com/thing:50878
Anniversary Roses by XYZWorkshop
https://www.thingiverse.com/thing:152642
Recommended Colors:
Red PLA (Hatchbox) for rose
Pink PLA (Hatchbox) for rose
Green PLA (Hatchbox) for stem
Light Blue PLA+ (eSUN PLA PRO)
White PLA (Hatchbox)
| bulb-and-sepal.FCStd | 133.6KB | |
| bulb-and-sepal.stl | 1.5MB | |
| filler-heart.FCStd | 103.4KB | |
| filler-heart.stl | 532.3KB | |
| filler-sphere.FCStd | 13.2KB | |
| filler-sphere.stl | 1.7MB | |
| filler-star.FCStd | 1.3MB | |
| filler-star.stl | 800.9KB | |
| stem.FCStd | 26.8KB | |
| stem.stl | 2.2MB |
