VAD-VAD Interlocking Block MOLD For Cement And Gips (Version 2) 3D Printer Model
The file 'VAD-VAD Interlocking Block MOLD For Cement And Gips (Version 2) 3D Printer Model' is (stl) file type, size is 5.9KB.
The file 'VAD-VAD Interlocking Block MOLD For Cement And Gips (Version 2) 3D Printer Model' is (stl) file type, size is 5.9KB.
File for casting a silicone mold from which you can make cement or gypsum VAD-VAD LLC Interlocking bricks
NOTE!
The difference between this mold and the previous version.
This version (V2) adds a mold for half blocks, which allows you to make blocks without using mortar.
The first layer is laid from half-blocks and then each next layer half overlaps the previous one.
Dimensions of one BIG brick:
Height: 20 mm
Width: 25 mm
Length: 50 mm
Dimensions of one HALF brick:
Height: 10 mm
Width: 25 mm
Length: 50 mm
In block design adding an offset between blocks for easier connection.
Offset length: 0.2 mm.
Actual BIG brick dimensions:
Height: 20 mm
Width: 24.8 mm
Length: 49.6 mm
Actual HALF brick dimensions:
Height: 10 mm
Width: 24.8 mm
Length: 49.6 mm
The file contains both the mold itself and removable side parts.
All you need to do is attach the sides with paper clips.
Suitable for both SLA and FDM printing.
Recommended printing parameters:
FDM (filament):
Layer thickness: 0.1 - 0.2 mm.
SLA (Epoxy):
Layer thickness: 0.05mm
Z axis lift speed: 2 mm/sec.
| vadVadBarV23.4.stl | 684.0B | |
| vadVadV23.2.stl | 15.5KB | |
| vadVadV23.3.stl | 15.5KB | |
| vadVadV23.5.stl | 684.0B |
