V2 1022 Magazine Loader 3D Printer Model
The file 'V2 1022 Magazine Loader 3D Printer Model' is (STL,STEP) file type, size is 26.4MB.
The file 'V2 1022 Magazine Loader 3D Printer Model' is (STL,STEP) file type, size is 26.4MB.
This is the basics of a 10/22 magazine loader. It works but could use some refinements. The hopper is an afterthought and needs higher walls. The base will also need extensions (or to be mounted to a board) to prevent tipping with a loaded hopper.
The hardware is just rubber bands, 3mm machine screws, a couple of clicky pen springs and some 3mm bamboo skewer sections as pins. Form the bamboo to fit the holes by using the parts as dies.
Really only need PLA+, 3 walls,15% cubic infill and a .2mm layer height for the large parts. the small parts should be printed at .12mm layer height with 4+ wall and at least %50 cubic infill. Use tree supports but make sure your settings allow for easy removal.
| 1022MagLatch_Lever.STL | 719.4KB | |
| 1022_Mag_Base.STL | 961.7KB | |
| Assem4.STEP | 21.4MB | |
| Bin.STL | 2.1MB | |
| Body_Latch.STL | 463.6KB | |
| Ext_Return_Rod.STL | 77.4KB | |
| Ext_Ret_Rod_Cap.STL | 2.2MB | |
| Face_Plate.STL | 2.2MB | |
| Feed_Gate.STL | 1.2MB | |
| Hatch_Bolt.STL | 1.1MB | |
| Hatch_Nut.STL | 9.9MB | |
| L_Lever.STL | 881.6KB | |
| MainBody_ReleaseLever.STL | 4.2MB | |
| Main_Base.STL | 4.2MB | |
| Main_Base_Top.STL | 2.9MB | |
| Main_Body.STL | 9.0MB | |
| Neck.STL | 5.1MB | |
| Opt_Plunger_Roller.STL | 1.2MB | |
| Plunger_Cap.STL | 7.0MB | |
| Plunger_Rod.STL | 706.0KB | |
| Ram.STL | 244.1KB | |
| Ram_Follower.STL | 179.4KB | |
| Ram_V1.STL | 244.1KB | |
| Top_Hatch.STL | 1.5MB |
