UStepper Nema34 Bracket 3D Printer Model
The file 'UStepper Nema34 Bracket 3D Printer Model' is (stl) file type, size is 25.0KB.
The file 'UStepper Nema34 Bracket 3D Printer Model' is (stl) file type, size is 25.0KB.
A Nema34 bracket for the uStepper. The uStepper is originally designed to fit on a Nema17 stepper motor, but has the capability to run some Nema34 motors (but be careful not to overload the driver chip!), so therefore I made a bracket for it!
On the back of the Nema34 there should be 4 holes spaced 64 mm apart on each side (center to center) - or approximately 90.5 mm when measured diagonally across the motors center. These four holes should be M4 and with a depth of approximately 1.8mm. There should also be a center hole with a diameter of 17 mm and a depth of approximately 6 mm.
Visit www.uStepper.com for more info.
| nema34_bracket.stl | 112.6KB | |
| nema34_bracket_magnet.stl | 13.0KB |
