Improved version of my filament clip.
Use it as you want:
Model is for 1,75mm filaments.
If you want to use it with 3mm you can easly resize it to 171-172%
I made a few versions on same base.
Original: Model is close to my first version but now its even easier to use.
Shark: Better looking 'brother' of original :) Should last little longer. It has a version with a hole too (not print-tested)
Print it only with 0.2mm nozzle or smaller. Maybe it will work for 0.3 but it was not tested. With 0.4 its too weak.
Curve: More standard model of clip with space only for one thread on the hook.
If it will loose its grip after many times used just heat it up with a hair drier with a rubber band (or sth else) around clip to hold it closed when heating.
More filament clip models:
Old version
Flat - wich I use as a main clip (version half tripple)
Small
| JG_filament_clip_v2_curve.stl | 824.3KB | |
| JG_filament_clip_v2_original.stl | 773.5KB | |
| JG_filament_clip_v2_shark_02noz.stl | 799.3KB | |
| JG_filament_clip_v2_shark_hole_02noz.stl | 876.6KB |
