USB Charging Outlet Mount For Bulletpoint Rubigrid Or Badland Dash Grid 3D Printer Model
The file 'USB Charging Outlet Mount For Bulletpoint Rubigrid Or Badland Dash Grid 3D Printer Model' is (stl) file type, size is 107.4KB.
The file 'USB Charging Outlet Mount For Bulletpoint Rubigrid Or Badland Dash Grid 3D Printer Model' is (stl) file type, size is 107.4KB.
*EDIT 8-18-24 Strongly suggest using a hi-temp filament. I found PLA+ getting soft on a couple other prints I have on my dash. I reprinted in ASA which survived perfectly last week on vacation in 85-90f outside temp with the sun beating through the windshield.
This print mounts to a BulletPoint Rubigrid and Badland Industries Dash Grid which holds two USB "A" and one USB "C" sockets for charging/power supply. (I'm working on the same print w/ 3 USB "A" sockets which I will add later)
The hole spacing is based on an AMPS mount, although it is "square" based on the long edge of an AMPS.
The usb sockets require a "buck converter"/12v to 5v converter to power them. DON'T forget and wire it up to the vehicle's 12v directly.
Print right side up with supports. I included a pic of the Cura "Fuzzy Skin" settings which is close to the texture on the dash of my 23 GMC Canyon.
The USB sockets were ordered through Aliexpress.
In "my designs", I have a few other prints to mount to the AMPS/M-Lok design on a BulletPoint Rubigrid and Badland Industries Dash Grid.
| USBamps2CC_1.stl | 357.8KB |
