US Vintage Gondola – Scale 1:32 – OpenRailway 3D Printer Model
The file 'US Vintage Gondola – Scale 1:32 – OpenRailway 3D Printer Model' is (STL,stl) file type, size is 2.6MB.
The file 'US Vintage Gondola – Scale 1:32 – OpenRailway 3D Printer Model' is (STL,stl) file type, size is 2.6MB.
I wanted a low sided gondola to go with my Bobber Caboose (http://www.thingiverse.com/thing:1363887). I had found the excellent G-scale Flat car by pmo (http://www.thingiverse.com/thing:183820) that suited my needs.So I've downsized it, redesigned the bogies and added slatted sides and new stakes.
The model can be printed to make a flat car, a flat car with stakes or a gondola.
I've used LGB knuckle couplers but they're a bit oversized and I'll try to design smaller ones later. You can also use standard LGB couplers.
| Axle_Cap_Print_8.STL | 49.5KB | |
| Brake_Wheel.STL | 635.1KB | |
| Flatbed_Front.stl | 824.9KB | |
| Flatbed_Middle.stl | 85.8KB | |
| Flatbed_Rear.stl | 814.3KB | |
| Flat_Bed_Stake_Print_14.stl | 7.3KB | |
| Frame_Front.stl | 804.7KB | |
| Frame_Middle.stl | 242.5KB | |
| Frame_Rear.stl | 568.1KB | |
| Gondola_Stakes_Print__14.STL | 13.2KB | |
| Outer_Axle_Print_8.STL | 9.8KB | |
| Slatted_Side_End_Print_2.STL | 5.7KB | |
| Slatted_Side_Lateral_Print_4.STL | 669.2KB | |
| Truck_Beam_Print_2.STL | 374.8KB | |
| Truck_Lateral_Print_4.STL | 1.7MB | |
| Truss_Rod_Print__4.stl | 75.2KB | |
| Washer_2mm._Print_2.STL | 327.6KB | |
| Wheel_Print_8.STL | 418.0KB |
