US Vintage Boxcar 1/32 3D Printer Model
The file 'US Vintage Boxcar 1/32 3D Printer Model' is (stl,STL) file type, size is 1.9MB.
The file 'US Vintage Boxcar 1/32 3D Printer Model' is (stl,STL) file type, size is 1.9MB.
This is a scale model (1/32 - Gauge 1) of a small boxcar used in the late 1890s.
It uses the same frame as my Bobber Caboose (http://www.thingiverse.com/thing:1363887) but almost everything had to be reworked.
| 01_Cabin.stl | 1.0MB | |
| 02a_Roof_with_brim.STL | 42.7KB | |
| 02_Roof.STL | 41.9KB | |
| 03_Axle_Bearing_3mm_Print_2.STL | 800.2KB | |
| 04_Door_Right.STL | 126.8KB | |
| 05_Door_Left.STL | 126.8KB | |
| 06a_Wall_Raiser_Left.STL | 587.5KB | |
| 06_Wall_Raiser_Right.STL | 587.2KB | |
| 07_Rail_Print_2.STL | 10.0KB | |
| 08_Front-Rear_Wall_Raiser_Print_2.STL | 7.6KB | |
| 09_Uncoupler_Support_Print2.STL | 79.2KB | |
| 10_Roof_Truss.STL | 33.5KB | |
| 11_Lower_Plateform.STL | 23.3KB | |
| 12_Roof_platform_rods_print2.STL | 58.1KB | |
| 13_Lower_platform_rods_print2.STL | 58.1KB | |
| 14_Lower_brake_shaft_bracket.STL | 84.5KB | |
| 15_Brake_Shaft.STL | 7.3KB | |
| 16_Brake_Wheel.stl | 1.1MB | |
| 17_Upper_Rung_Print_11.STL | 145.0KB | |
| 18_Lower_Rung_Print_2.STL | 145.0KB | |
| 19_Upper_Bracket_Print_4.STL | 17.5KB | |
| 20_Lower_Bracket_Print_6.STL | 8.9KB | |
| 21_Small_Ladder_Print_4.STL | 18.1KB | |
| 22_Wheel_Print_4.STL | 539.3KB | |
| 23_Door_Handle_Print_2.STL | 130.2KB | |
| 24_Coupler_holder.STL | 166.4KB | |
| 25_Roof_Handrail.STL | 217.0KB | |
| 26_Outer_axle_3mm.STL | 14.7KB | |
| 27a_Brake_Right_print_2.STL | 25.5KB | |
| 27_Brake_left_print_2.STL | 25.5KB |
