Two color drawer labels for the US General 26" chest from Harbor Freight. Pause at layer 7 in the G code to switch filaments. They do slide quite easily in the slot so you can either use super glue or an adhesive to hold them in place if desired.
Overall dimensions of each plate:
Without the letters on the base plate: .06in thick x .66in wide x however long the letters are
Letter Dimensions: .47in wide x .055 thick x however long the word is
RAISE THE LETTERS .06IN OFF THE BUILD PLATE IN TINKERCAD TO SET FLUSH ON THE BASE PLATE
^Use this if you wish to recreate any of the items in Tinkercad
| Drill_Bits.stl | 309.8KB | |
| Electrical.stl | 334.9KB | |
| Grease_Gun.stl | 413.3KB | |
| Grinder.stl | 297.7KB | |
| Hammer.stl | 305.0KB | |
| Hardware.stl | 363.6KB | |
| Heat_Gun.stl | 270.0KB | |
| Pliers.stl | 234.7KB | |
| Pry_Bars.stl | 343.9KB | |
| Ratchets.stl | 336.4KB | |
| Screw_Drivers.stl | 538.3KB | |
| Sockets.stl | 291.8KB | |
| Wrenches.stl | 365.3KB |
