Attention: this is a WIP project.
With this holder u can use 6 wire spool (Zivipf spool: about 55x10 mm) during the rebuilt of your atomizer.
In the front panel u can attach some label to describe the specified wire.
U need too:
U can print the body WITHOUT support.
About the wire_lock there are two solution:
For bigger wire (kh & nicr > 0,40) i suggest use the stopper version.
For other one u can use the normal version.
If u do not like the stopper version u can use to friction the spool some adhesive sponge (like in the shots).
| body_6_spool.stl | 1.1MB | |
| body_6_spools.stl | 1.2MB | |
| front_panel.stl | 80.7KB | |
| front_panel_for_label.stl | 78.0KB | |
| single_wire_lock.stl | 211.4KB | |
| spool_stopper.stl | 86.4KB | |
| wire_lock_6_spool.stl | 668.1KB | |
| wire_lock_for_spool_stopper.stl | 205.6KB |
