Unklicky Filament Runout Sensor 2 3D Printer Model
The file 'Unklicky Filament Runout Sensor 2 3D Printer Model' is (stl,step) file type, size is 1.3MB.
The file 'Unklicky Filament Runout Sensor 2 3D Printer Model' is (stl,step) file type, size is 1.3MB.
I have been using the Unklicky filament sensor on VoronMods, but it has been unreliable; the pin and roller wear out frequently.
This should last much longer. The two magnets on the left must be in the same orientation so that they repel. N52 grade magnets would be much better; however, N35 should also work.
Update 24/6/2024:
Soldering job gave up after a while, so I crimp JST XH 2.54 connector pins to wiring and use that for male connector joint.. see pics..
BOM:
1x - PETG
3x - 6x3mm N52 grade magnets
1x - JST XH 2.54 male connector
1x - M3 heat-set insert
1x - M3x6mm BHCS/SHCS
1x - M3x16mm BHCS/SHCS
2x - M2.5x6mm SHCS
2x - M2.5 hex nuts
| filament-sensor-body.stl | 1.9MB | |
| filament-sensor-lid.stl | 1.4MB | |
| filament-sensor.step | 827.2KB |
