This is a two-part spool holder designed to accommodate many spool sizes, including 3kg and 1kg rolls. The holder uses a screw that prevents the spool from falling out. I recommend using a honeycomb print pattern with at least 20% infill with PLA, but it depends on the spools you're going to use. Oh also this spool holder you can print on a 7" bed.
Enjoy!
Supported Spool Sizes: can fit up to 10" diameter spools with 5" depth. The diameter of the shaft from the body is 2.05".
NOTE SCREW V2 IS NOT TESTED The Differences between Screw and Screw V2 is that Screw V2 has a shorter thread and has a small guide so it should be easier to start the thread.
Tested with this 3kg roll: https://www.amazon.com/OVERTURE-Filament-Cardboard-Dimensional-Accuracy/dp/B0BDLV89JQ?th=1
| Screw.STL | 2.2MB | |
| Screw_V2.STL | 2.6MB | |
| Spool_Holder_Body.STL | 3.0MB |
