Universal Snow Chains/spikes For Crawler And RC Cars 3D Printer Model
The file 'Universal Snow Chains/spikes For Crawler And RC Cars 3D Printer Model' is (stl) file type, size is 2.9MB.
The file 'Universal Snow Chains/spikes For Crawler And RC Cars 3D Printer Model' is (stl) file type, size is 2.9MB.
I was tired of searching for snow chains for my RC models. Most of them have poor quality and no good effect.
These are universal snow chains for RC Cars! This file fits 110-125mm wheels but you can scale.
The performance is impressive. The use is intended for crawlers, but basically any off-road vehicle with rims can use it.
Check out my video: https://www.youtube.com/watch?v=RNmkUzKfRU0
note: When using with portal axes you may need an offset for fitting well.
Also make sure the loop is on the outside of the wheel and not on the inside.
instagram: https://www.instagram.com/spezi_lover/?hl=de
Update 22.1.23
Fixes and new V3
| Schneekettev1.stl | 710.7KB | |
| Schneekettev2.stl | 5.9MB | |
| SchneeketteV3.stl | 3.3MB |
