Credits to the original author disser for the wonderful original design.
I just chopped off the sides of the base, still allowing the model to stand. I also shortened the height of the model and raised the lip of the bottom cylinder to allow more safety razor compatibility, making it easier to grab and store short or long razor heights.
I originally intended to design this for my Merkur 39c slant razor, but I switch razors interchangeably here and there, so I thought to just make this stand a universal design. I can confirm it works on a Merkur 34c, Merkur 39c, Muhle R41, and most likely other traditional safety razor designs.
This stand will balance on its own without additional adhesives, but for mine, I put some 3M double sided tape on the bottom to keep it in my place just in case. Prints averagely in just an hour or under due to it's simple and minimal design.
| Razor_Stand.stl | 2.3MB |
