This Cellphone stand can be used for Photo and filming and fits a wide range of Cellphones.
from 10 x 5 cm to 16 x 8 cm. For larger phones or iPad you can always scale it up in the slicer before printing.
For iPad use upscaling in slicer by 160% and use HookArmShort_6_11cm because iPad are relatively wider than an iPhone. By scaling 160% you should get the dimension up to 17.5cm width and 25.5cm Long for iPad. Use AttachArm160 for scaling so AttachScrew will fit.
While scaling for iPad you don’t need to scale AttachArm160, TablePlate and CameraStands. But if you want a bigger Tableplate, you can scale AttachArm and TablePlate by 160% as wel.
CameraStands is used for attaching to a Camerastand with standard ¼ inch screw.
CameraStandThread has ¼ inch tread built in and CameraStandNut you must attach a ¼ inch nut yourself.
Use 6mm wings crew and nut for attaching AttachArm and Tableplate.
| AttachArm.stl | 405.8KB | |
| AttachArm160.stl | 417.4KB | |
| AttachScrew.stl | 776.5KB | |
| CameraStandNut.stl | 242.6KB | |
| CameraStandThread.stl | 538.2KB | |
| DiscPlate.stl | 375.1KB | |
| HookArmDobbel1.stl | 167.0KB | |
| HookArmLong.stl | 56.6KB | |
| HookArmShortOne_5_8cm.stl | 71.8KB | |
| HookArmShortOne_6_11cm.stl | 63.6KB | |
| HookArmShortTwo_5_8cm.stl | 71.8KB | |
| HookArmShortTwo_6_11cm.stl | 63.6KB | |
| SquezeNut.stl | 834.7KB | |
| SquezePlate.stl | 1.0MB | |
| TablePlate.stl | 363.9KB |
