This is a remix of Ultramodern Soap Dish (public domain) by Anenome:
https://www.thingiverse.com/thing:1394419

In this remix, I removed the feet so the dish will print without supports. However, I wanted feet so that water will not pool up inside the dish. So in place of the feet, I put holes in the size of the filament. Then 3 small pieces of filament can be used as feet. See the Post-Printing section below for instructions.

Edit 04/15/2020: I've remixed both styles of soap dishes to add slots on the bottom to allow the water to drain. No need to add feet - so the Post-Processing section doesn't apply to these files. The slots are angled at 45° so they will print without supports and they have been placed so they are not visible when the dish is right-side up. These files can also be scaled as needed because there are no holes that must be a certain size. These are the files named Soap Dish Rounded Top w Slots.stl and Soap Dish Squared Top w Slots.stl.

The versions with feet as described above are named Soap Dish Rounded Top w Feet.stl and Soap Dish Squared Top w Feet.stl.

Note: If the .zip file that is downloaded using the Download All Files button contains only the two original files, then click on the Thing Files button and download the four files individually. I have also made a correction to the squared-top with feet version, so if you want to print it, you'll want to download the new one. The rounded-top with feet version remains unchanged, except for its name.

I also removed the outermost pieces as I felt they were too thin and easily broken.

The result is a sturdy soap dish that prints without supports and has feet (or slots) to allow water to drain away.

I've included remixes of both styles of soap dishes - squared-top and rounded-top.