ULTRA SLOW STICK- FUNFLY STYLE – LANDING GEAR BLOCK – NEW MOTOR MOUNT 3D Printer Model
The file 'ULTRA SLOW STICK- FUNFLY STYLE – LANDING GEAR BLOCK – NEW MOTOR MOUNT 3D Printer Model' is (dwg,stl) file type, size is 6.4MB.
The file 'ULTRA SLOW STICK- FUNFLY STYLE – LANDING GEAR BLOCK – NEW MOTOR MOUNT 3D Printer Model' is (dwg,stl) file type, size is 6.4MB.
Going to insert either two flat 6mm carbon strips or two 5x5 tubes down to a Single E-flite Wheel Set Timber EFL5258, and add carbon strips/tubes to end of the wing tips.
Also developing a new motor mount that will remove that terrible down facing angle.
Used a heat gun on the motor mount to soften some so that ball can be pushed into shell.
| ULTRA_SLOW_STICK_-_THRUST_VECTORING_MOTOR_MOUNT.dwg | 4.7MB | |
| ULTRA_SLOW_STICK_-_THRUST_VECTORING_MOTOR_MOUNT.stl | 2.6MB | |
| ULTRA_SLOW_STICK_-_THRUST_VECTORING_MOTOR_MOUNT_-_TIGHT_TOLERANCE.stl | 2.9MB | |
| ULTRA_SLOW_STICK__-_LANDING_GEAR_BLOCK.stl | 626.0KB |
