I cut the watch stand from the one made by @ScanSource3D. The problem is that I didn't like the print when I would lay it flat on the side and the extrusion lines wouldn't be in the best layout for support and structure. So re-did everything going off of the measurements from http://www.thingiverse.com/thing:864011
With having 3 parts to print you can lay them flat to get a good structure for them.
I didn't sink the charger all the way down in the part because I wanted a little space between the top of the charger and the model. You can see in one of the pictures above.
Why so many parts?
I made this so that you can have an Apple Watch stand that is left or right oriented. It is up to you. If you are really cool and have two apple watches, you could connect both sides and have a sweet little watch stand.
This is probably the only Double Apple Watch stand out there (probably not). If you do the Twin watch stand, you most likely will have to do it in ABS and then use Acetone to weld both sides on. You will want to print the "no holes" .STL files for that.
I have supplied files with holes that take a 20mm M3 screw and washer. You may want to tap (M3 x .05 tap) out the holes because I made them tight. I have also supplied files without holes if you want to weld them up with Super Glue or Acetone.
If you want a LEFT facing stand (support on right) with holes for screws
If you want a RIGHT facing stand (support on the left) with holes for screws
If you want to glue/weld (no screws)
If you want the TWIN (watches on both sides)
| left_watch_stand_base.stl | 89.0KB | |
| left_watch_stand_side.stl | 355.7KB | |
| left_watch_stand_top.stl | 154.1KB | |
| right_watch_stand_base.stl | 421.7KB | |
| right_watch_stand_side.stl | 243.2KB | |
| right_watch_stand_top.stl | 154.1KB | |
| twin_watch_stand_base_left_no_holes.stl | 354.8KB | |
| twin_watch_stand_base_right_no_holes.stl | 365.2KB | |
| twin_watch_stand_side_holes.stl | 355.7KB | |
| twin_watch_stand_side_no_holes.stl | 10.4KB | |
| twin_watch_stand_top_left_no_holes.stl | 97.6KB | |
| twin_watch_stand_top_right_no_holes.stl | 97.6KB |
