UHF Satcom Antenna 3D Printer Model

License: CC BY-NC
File formats: STL
Download type: zip
Size:222.4KB

The file 'UHF Satcom Antenna 3D Printer Model' is (STL) file type, size is 222.4KB.

Summary

This is a re-design of the popular DIY UHF Satcom antenna which was published several years ago in the special interest magazine MONITORING TIMES.
The so called „MT Omni X-wing“ antenna was designed for a fixed setup. My Re-design is more like the commercial antennas in use by the army. The antenna is mounted onto an ordinary camera tripod, instead of a fixed mesh ground reflector. The mesh is replaced by 6mm radials as reflector.
The mounting of the two dipoles is covered with a printed housing. The housing can hold a director boom, if someone need it.
More about the details of my re-design can be found on my blog: http://diebastelkammer.wordpress.com

I whish everyone a good re-build
73

Bodenstuck_r2_v01.STL 284.1KB
Deckel_fur_Dipol-Montageplatte_v01.STL 229.8KB
Dipole-Montageplatte_r2_v01.STL 168.7KB
Kabelhalter_fur_Radial_v01.STL 89.9KB
Schwenkvorrichtung-Oberteil_r2_v01.STL 120.6KB