UFS-067 Lawn Mower Oil Funnel Or Small Engine Oil Funnel 3D Printer Model
The file 'UFS-067 Lawn Mower Oil Funnel Or Small Engine Oil Funnel 3D Printer Model' is (stl) file type, size is 937.3KB.
The file 'UFS-067 Lawn Mower Oil Funnel Or Small Engine Oil Funnel 3D Printer Model' is (stl) file type, size is 937.3KB.
I’ve been collecting funnel ideas for awhile. I’ve downloaded parametric models that you can customize however you like. I also downloaded several with interesting shapes.
This was all because I needed a funnel with a long spout to reach the oil fill on a lawn mower and also a generator. The access is terrible, and I originally spilled a lot of oil trying to fill up the oil level.
Then I came across the Trailer Water Fill Funnel. I liked the flat side. That really helps bring the funnel closer to the side of the item being filled. It just needed an extra long spout.
I didn’t want to use supports, so I angled the top of the funnel. When printed upside down, the sides are steep enough that I didn’t need any support. You can add them if you want, but they can be a pain to remove from the spout.
There are two models. The first one I printer, and a second one with a slightly longer and narrower spout.
Beware, Cura didn’t like this model. I had voids in a couple of spots. I had to adjust settings to get it to print. Make sure you preview before printing.
| Mower_OilFunnel01-Filler.stl | 1.1MB | |
| Mower_OilFunnel02-Filler.stl | 1.1MB |
