P.S. : if you have download it before 15.08.2021 please download it again there was an alignment issue with bumps and holes.
if you have already printed it. you can fix it by removing bumps of file down to a smaller size.
I wanted to make my own candles for this nice little lantern it works well.
As long as you use thin wick.
If thicker wicks used results are not so good and it will end up melted parafin over flow.
wick holder is not good enough but its better than nothing
any way if you need to change something
you can use link below
https://cad.onshape.com/documents/735367d0194572bf70eb328f/w/da120532593c93544643461e/e/ff64f417e916e4077359d4cc
| CLAMP.stl | 1.1MB | |
| UCO_Candle_mold_fixed.stl | 4.6MB | |
| UCO_Candle_mold_long.stl | 4.6MB | |
| wick_holder.stl | 52.8KB |
