This model is a tight-ish fit, if you want it to have a tiny bit of play on the device, you might want to increase the size by a few percent.
printing oriantation: standing up on the backside (with the lips).
Recommanded print settings:
- 0.6mm+ nozzle.
- 3 or 4 perimeters.
- 3 top and 3 bottom solid layers.
- 15% or more gyroid infill (15% will be sufficiant).
- 0.40mm or 0.55mm since this is a structural part, no need to make it nice.
- Supports: Optional if you want the screwholes neatly round.
- Every other setting is the stock Prusament PETG setting in 0.6/0.8mm nozzle config.
