Ubiquiti UNIFI U6 Mesh Outdoor Wall Mount 3D Printer Model
The file 'Ubiquiti UNIFI U6 Mesh Outdoor Wall Mount 3D Printer Model' is (stl) file type, size is 48.4KB.
The file 'Ubiquiti UNIFI U6 Mesh Outdoor Wall Mount 3D Printer Model' is (stl) file type, size is 48.4KB.
Created this to use under the eves on the wall outside to hold my U6 Mesh AP
Has drain ports on the inside bottom to wick water away.
I heat set a M3 X 6 X 5 Nut
Use a M3 X 12 Stainless Screw as a set.
If you don't want to do this hardware, you can use a drop of silicone as well.
Used PETG
Used Minimal support for large side hole
Supports not needed for set screw boss
| Ubiquiti_U6_Mesh_Wall_Mount.stl | 189.7KB |
