Tybalt the Garden Gnome, by itech3dp. I split him so he can be printed with minimal supports, and twice the size if you print each half separately!
I use Cura 3.6+ with Experimental>Tree Supports as this is the easiest supports to remove once dialed in. His nose, boots & the back of his hat need the support mainly.
+=+=+=+=+=+=+
I did further splitting so you can actually print him in 4 different pieces, all oriented flat on the print bed, with no supports necessary. More time consuming? Yes. No supports though, because I HATE supports!
Pro Tip: Once he is printed & super glued together, put baking soda in the seam & then drip super glue in to it. Wait a few minutes & then sand smooth.
Then he can be painted!
Thanks to itech3dp for the awesome model!
| Tybalt_Bottom.stl | 9.7MB | |
| Tybalt_Bottom_A.stl | 6.3MB | |
| Tybalt_Bottom_B.stl | 3.5MB | |
| Tybalt_Bottom_Split.stl | 9.9MB | |
| Tybalt_Split.stl | 19.3MB | |
| Tybalt_Top.stl | 9.6MB | |
| Tybalt_Top_Split.stl | 9.9MB | |
| Tybalt_Top_Split_A.stl | 6.3MB | |
| Tybalt_Top_Split_B.stl | 3.7MB |
