Two Trees SK1 Camera Mount 3D Printer Model

Author: @
License: CC BY-SA
File formats: stl
Download type: zip
Size:784.5KB

The file 'Two Trees SK1 Camera Mount 3D Printer Model' is (stl) file type, size is 784.5KB.

Summary

This is a 2 or 3 part print, based on your camera mounting needs.
This uses the Two Trees holes in the case for mounting the camera.

Minimum hardware needed, 3 M3x8 bolts, hinge point is designed for caphead.

if your camera mounts with a 1/4-20 bolt, you will need one at 1/2" long to fit properly, and not be too long or too short.

If you have heatserts, the M3x6 will fit into all 3 holes in the heatsert camera base.

The nosert prints are for those who have M3 hardware, and holds sufficiently on first attachement, but I make no promises for hole reuse if it needs to be removed repeatedly.

The elp is for the camera series with 40mmx40mm sides backer boards, and requires 4 M2x8 bolts, and if using heatserts any up to 4mm in length will work.

the 0.25-20 is the 1/4-20 mount for cameras with a 1/4"-20 thread hole to mount them by, like the Logitech C615 which also may need the spacer washer to get the mount to be flat to the base.

The mounting finger was designed to be pointed upwards or downwards, to allow for more control over the lens location.

These when printed on the Two Trees, in PLA or PETG, you should aim for roughly 20% infill, and its designed to print correctly with no supports.

All objects are designed to load and print without any rotation needed.

Camera_mount_0.25in-20.stl 314.4KB
elp_Camera_mount_backcover.stl 635.4KB
elp_Camera_mount_heatsert.stl 882.3KB
elp_Camera_mount_nosert.stl 882.3KB
logitech-washer.stl 140.7KB
SK-1_Camera_base-heatsert.stl 324.6KB
SK-1_Camera_base-nosert.stl 324.4KB