A two-piece 40deg camera mount I made for the Foxeer Pico Razer on my UWL builds.
Two piece camera mount makes printing easier, assembly easier, gives a more secure restraint of the camera, is less prone to delamination failures in the lens holder area, and looks pretty good I think.
Print the lens holder 'flat' for maximum strength (see attached slicer image for reference). The lower portion does not require supports, the upper lens holder portion prints cleaner with supports just under the two retaining features.
To assemble:
1) Flex open the upper lens holder portion slightly, and then press the camera lens into position. It should slightly 'click' once in the right position.
2) Mount the camera / lens holder to the lower base. Be sure the screw holes in the upper and lower portion are aligned (might require some pressure)
3) Use a screw to fasten the upper and lower portion together. I used a M1.2x5 screw, although I'm sure several sizes would work. I think you could even use a thin piece of tied off wire to hold the whole thing together.
Still a work in progress. Let me know your experiences and I'll continue refining. Thanks!
| Two_piece_FRN_mount_40deg___lower_rev7.stl | 1.1MB | |
| Two_piece_FRN_mount_40deg___upper_rev7.stl | 314.4KB |
