!!!!!! UPDATE #1 March 19,2023 !!!!!

The new holder for the WYZE V3 Cam (File 1002c_WYZE_V3_HOLDER) has been modified to require less support and to make it easier to remove the supports. The area around the 'push down retainer' the holds the v3 in the holder bracket has been given a 45 degree slope and will print without supports in this area and this makes it easier and less likely to damage the fragile push down retainer.

I would strongly recommend that you use print the new version (1002c_WYZE_V3_HOLDER)

Two Part Pegboard Mount for Wyze CAM V3

This design is a remix of my Pegboard mount for a Wyze CAM V2 to accomodate the V3.

https://www.thingiverse.com/thing:4335549

This posting contains three files

File 1001 Pegboard Bracket with a Cable Management Slot
File 1002b Wyze Cam V3 Holder. (The Cam Holder also has a 'spring' to help steady and hold the part in the Pegboard Bracket)
File 1009 Cable Retainer

While there is a considerable amount of support required to print these objects, it is strongly recommended that the components be printed with the orientation as provided in the files to ensure maximum strength in the components. A 'cable management' slot has been Incorporated in the Pegboard Bracket to restrain the Cam V3 power cable.

Note 1:
The the retaining clip or 'bump' on the part of the Cam V3 Holder that fits into the Pegboard Bracket will lose some of it's memory over time but the reduced force should still be sufficient to steady the unit and offer some resistance to prevent it from falling out.

Note 2:
The components have been designed for a snug fit. If the Cam V3 Holder will not slide into the Pegboard Bracket sand the Cam V3 Holder with a 150 to 200 grit to round the edges and reduce the width.

It is not uncommon to find small variations in pegboard hole sizes. Sometimes the Pegboard Bracket will require a firm push to mount. If the components are printed with four walls and in accordance with the recommended orientation the pegs will be relatively strong and should not break. If the Pegboard Bracket can not be inserted, carefully ream out the pegboard holes to a slightly larger size.

Listing of all Wyze Pegboard Accessories in the Pegboard Series

This is one in a series of pegboard accessories. The set includes the following items that have been designed for using Wyze products with pegboards. Check
https://www.thingiverse.com/burke9119/
to see when more are added.
1 Two Part Pegboard Mount for a Wyze CAM V2
https://www.thingiverse.com/thing:4335549
2 Two Part Pegboard Mount for a Wyze Contact Sensor Switch Holder
https://www.thingiverse.com/thing:4337294
3 Wyze Motion Sensor Pegboard Mount
https://www.thingiverse.com/thing:4350830
4 Wyze Vault with Pegboard Mount
https://www.thingiverse.com/thing:4588130
5 Wyze Pegboard Cable Management Kit
https://www.thingiverse.com/thing:4590517