Two Dragonair Parted 3D Printer Model
The file 'Two Dragonair Parted 3D Printer Model' is (STL) file type, size is 9.8MB.
The file 'Two Dragonair Parted 3D Printer Model' is (STL) file type, size is 9.8MB.
This model is parted for convenience for printing and painting as well give it limited action of head rotation, and provide pre-built supports for printing.
it re-edited with my simple ball joint desgin, it possible that can happend neck of head's ball can broken off. but not often.
If you made it, Please share your make on original source and not here.
https://www.thingiverse.com/thing:1742921
Thank you Bisic for most beatiful dragonair model in thingiverse!
| Head.STL | 2.1MB | |
| Head_Supported.STL | 2.2MB | |
| Head_Winged_earfin_A.STL | 657.1KB | |
| Head_Winged_earfin_B.STL | 662.1KB | |
| Head_Winged_earfin_C.STL | 592.3KB | |
| Lefty_Body.STL | 2.3MB | |
| Lefty_Body_Supported.STL | 3.6MB | |
| Lefty_Neck_Jewel.STL | 89.7KB | |
| Righty_Body.STL | 1.6MB | |
| Righty_Body_Supported.STL | 2.6MB | |
| Righty_Neck_Jewel.STL | 89.7KB |
