This is an optional base for the Twist Lock Trick Box.
This Open Frame base comes in two versions. One version is pre-supported with sections that will pop out after printing (some force and wiggling may be necessary if the clearances involved are too tight for your printer). The other version requires either extremely good cooling or generated supports.
Add your own photos, lithographs, or printed plates - just make sure the items used are less than 1.5mm thick and 38mm by 42mm.
| Blank_Panel.stl | 684.0B | |
| Celtic_Knot_Panel.stl | 371.3KB | |
| Open_Frame_no_Supports.stl | 69.6KB | |
| Open_Frame_with_Supports.stl | 102.4KB |
