This is my Tweaker 180 Parts. I modified pretty much every file on this list to be able to make it work for me.
Thanks to the guys who did the original work!

Check back as I am trying to make this design better and every time I find something to improve upon, I try to.

Be sure to print 2 Doors and 4 Feet..

EDIT+++ I found a couple of errors in my STL files and have corrected them. If you have already download, please download again. Also added file called Tweaker Post. A friend wanted a color that didn't match his support posts. this part will cover the center post that do not have printed parts on them. this is to make it match the rest of the color scheme. Modified door so that model is upside down to save on support material and strengthened latch points 2/3/16

Added another door flipped the other direction to give more mounting options. Modified camera mount to have thicker sidewalls where screws tighten down to lock camera angle. Didn't feel I was able to tighten camera enough and was worried about it changing angles during flight. 2/4/16

Added another mount for my lemon RX Satellite Receiver. This will allow you to mount it from the top instead of the bottom. This is handy because if I remove the top plate I have to mess with the antennas. With this new setup the receiver and antennas will pull off together as one piece. 2/6/16

Wanted to move my RX farther forward, made a mount for my Lemon RX Satellite that sits between the camera and board stack. 2/10/16

Upgraded batteries and they had an XT-60 connector on them. Much better connector than the Deans I was using. Modified Rear to house the XT-60 plug, I glued it in place. Works very nice for cable management and keeping the wires out of the props. Left the older file on here so if you don't use the XT-60 plug you can use that STL instead. 2/26/16