Triple Picatinny Rail 3D Printer Model
The file 'Triple Picatinny Rail 3D Printer Model' is (stl) file type, size is 914.6KB.
The file 'Triple Picatinny Rail 3D Printer Model' is (stl) file type, size is 914.6KB.
UPDATE: After a few months of testing with this design, I found that the original design was very weak. Thus, I remade this thing using the Dual Angled Rail by T-san, which is itself also a remix of the Dual Picatinny Rail, but using full-length teeth for strength. I also improved the fitment of the rail onto other rails by buffing up the female part of the rail at the bottom.
ORIGINAL:
This is a remix of harddrv1's Dual Picatinny Rail. I extended the length to 10cm and added the third rail on top while retaining the screwports. I raised the middle rail because I was concerned you won't be able to use all three rails together, but I'm not sure if that's enough. I did lose the logo though. There was nowhere else to place it.
There are two variants to the model:
Feel free to give your comments, especially about usability and practicality.
| Triple_picatinny_rail_1.5cm_centered_screw_holes_.stl | 1.6MB | |
| Triple_picatinny_rail_1.75cm_centered_screw_holes_.stl | 2.0MB |
