This is a 3D Lamp model of the Triforce from Legend of Zelda saga games.
It is designed for 4x 5mm bulb LEDs, but can be used withs smd. Make sure you use the proper circuit to light it up. I used 3v 20mA LEDs, in sets of two, with a 150ohm resistance
Button cap with Hylian Shield Desgin with a 3mmx2mm hole to insert the square button pin.
The hollow yellow pyramids must be glued in position, but it has a 3mm overgrowth so they fit right in.
Brightness depends on the LED you use, but its not a reading lamp, just decorative.
9v battery may need a layer of tape as seen in the pictures so it doesn't fall from the slot.
Files to print:
1x piramide_central
1x Tapa_central
1x Boton
4x piramide_costados
Support needed only for "Boton"
| boton.STL | 269.0KB | |
| piramide_central.STL | 34.9KB | |
| piramide_costados.STL | 684.0B | |
| Tapa_Central.STL | 169.2KB |
