Trifecta Cooling Fan Duct 3D Printer Model
The file 'Trifecta Cooling Fan Duct 3D Printer Model' is (stl) file type, size is 9.1MB.
The file 'Trifecta Cooling Fan Duct 3D Printer Model' is (stl) file type, size is 9.1MB.
Re-designed from the ground up - inspired by Madau3D's Ductinator - I present the Trifecta Fan Duct for 3 fans (40 mm), for the Ender 3 / CR10 for a custom mount that goes on a MG12H linear rail block.
This comes with a little standoff block that you can mount the BLTouch onto on the back of the custom mount. Timing belts goes through the small slits in the top on each side.
| E3CS_FanShroudL.stl | 4.8MB | |
| E3CS_FanShroudR.stl | 4.8MB | |
| E3CS_HeatsinkCooler.stl | 2.2MB | |
| HotendMount-BLTouch.stl | 711.8KB | |
| HotendMount.stl | 2.5MB | |
| TrifectaFanShroud.stl | 9.7MB |
