Traxxas TQI Phone Mount (Glue On) 3D Printer Model
The file 'Traxxas TQI Phone Mount (Glue On) 3D Printer Model' is (stl) file type, size is 113.3KB.
The file 'Traxxas TQI Phone Mount (Glue On) 3D Printer Model' is (stl) file type, size is 113.3KB.
This is a phone mount I designed to be glued on my Traxxas TQI transmitter. It will need to be assembled with the hardware listed below and attached to the controller. I used some e6000 to glue mine on and it works well. I also have made a few slight changes since I printed the one in the pictures, so if something doesn't work, leave a comment. (The phone case in the pictures is just thrown in there to show that it fits an iPhone 13 with a larger case)
Required:
2 x Rubber Bands
1 x M4 * 20 bolt
1 x M4 washer
1 x M4 nut
2 x M5 * 16 bolts
2 x M5 * 12 bolts
4 x M5 washer
5 x M5 nuts
Assembly Instructions:
Every bolt is a button head bolt with a washer on the back side with the nut. The two M5 x 12 bolts will go through the clamp mount and the bottom of the phone clamp to attach them. Then the single M4 screw will go through the hinge between the swivel and clamp. The other two bolt holes are for the M5 x 16 bolts with the one on the back of the phone clamp having two nuts(one for a jam nut) unless you have a locknut. The rubber band sits in the slots on the back.
| Clamp_Mount.stl | 48.1KB | |
| Controller_Mount.stl | 26.8KB | |
| Phone_Clamp_Bottom.stl | 88.3KB | |
| Phone_Clamp_Top.stl | 50.4KB | |
| Swivel_Mount.stl | 52.0KB | |
| Traxxas_Phone_Mount.stl | 263.3KB |
