All the bits you need for a mini travel sized version of the game cathedral, and the source code to print a larger version.
Print one each of the lid, playing board and lid_clip pieces for the travel case and board. There is room for a 1x10x20 magnet on the lid and the lid clip -- with those glued in, the board seals pretty well and should travel fine.
Choose different colors for each player, and a 3rd color for the cathedral. I recommend that the board and lid pieces be printed in either a 4th color, or the same as the cathedral. (You can also use an MMU printer to print the grid as a separate color as shown in the one photo)
For player one, print 1x of every piece except the "abbey player 2" and "academy player 2" and print 2nd copies of the tavern, stable, and inn pieces.
For player two, chose a different color, and print the same, substituting the two "player 2" pieces for their namesakes.
Print the cathedral piece in a 3rd color.
You could probably just scale this up, but I recommend using the enclosed scad file so you can control spacing on the grid and between pieces.
| abbey.stl | 11.5KB | |
| abbey_player_2.stl | 11.5KB | |
| academy.stl | 6.8KB | |
| academy_player_2.stl | 6.8KB | |
| bridge.stl | 3.6KB | |
| castle.stl | 19.4KB | |
| cathedral.scad | 17.0KB | |
| cathedral.stl | 10.2KB | |
| infirmary.stl | 7.3KB | |
| inn.stl | 4.3KB | |
| lid.stl | 6.7KB | |
| lid_clip.stl | 18.2KB | |
| manor.stl | 11.0KB | |
| playing_board.stl | 54.7KB | |
| square.stl | 4.1KB | |
| stable.stl | 2.2KB | |
| tavern.stl | 1.3KB | |
| tower.stl | 20.1KB |
