This is an upgrade for Protectobot Rook from the Transformers Combiner Wars toy line by Hasbro.

This upgrade is designed to slide on/ around the back of Rook's calf in order to cover up the serial numbers shown in robot and limb mode as well as to cover the the gaping whole in limb mode. The upgrade also can be kept on for every mode, including vehicle.

Notes:
*The STL file contains only the upgrade for the left leg, in order to print out the upgrade for the right leg you will have to upload the STL into your splicer and mirror it.

*The upgrade is in two pieces, the "Panel" and the "Connector". You will have to super glue the "Connector" to the "Panel" 1cm down from the top, best mess around with the individual pieces so you get the idea of how it will sit on the figure (Before gluing). The reasoning behind this is when i tested it as one piece the bottom layer would be horrible quality and would not fit (with support used and removed).

Thank you for checking out my models, please take a look at my other designs and follow me on my social media to keep up to date on my creative adventures!

Twitter: www.twitter.com/Alanfarout
Instagram: www.instagram.com/faroutalan
Linkedin: www.linkedin.com/alanhenry113