This is an upgrade for ToyREP 3D Printer, that will allow you to attach LED power supply under the Y axis, so it is a solid part of the printer.
Cover is now available for two sizes. Use ToyREP-PSU1 for 111x78x36mm or ToyREP-PSU2 for 129x99x38mm. The instructions are the same for both.
It have a main power switch and covering all the dangerous connections to make the printer safer. As was already mentioned in the printer description, 40W 12V should be just enough for hotend and movement. For 100x100mm heat bed you will need approximately another 40W. That makes total 80W. I am currently using 75W PSU. It is sufficient for printing when heaters are already heated up and consuming less energy, but I have to be cautious and not switch heat bed and hotend at once.
The major disadvantage of this thing is, that PSU have to be installed at the very beginning of ToyREP assembly. For latter upgrade you will have to disassemble almost the whole printer.
| ToyREP-PSU1.stl | 44.1KB | |
| ToyREP-PSU2.stl | 39.0KB |
