Hey Guys,
My Toyota Aristo jzs147 uses a clip to hold the 2 throttle cables to the factory strut brace, in my case, the clips were broken, so i remodelled them in sketchup, this is revision 1.1, i lost my rev 1 STL files, i havent printed with his rev, but it should work the same, i think this one will work better, you'll have to resize it to 26.25mm x 28.5mmx 4.2mm though, it should provide a nice tight fit, if its too tight, try increase the X and Y size by 1mm.
You'll have to print in something high temp, like ABS, as the clips sit right above the turbos.
The Dyna and Toyoace use the same clip, but to hold the handbrake cable!
Toyota part number is 90469-10003
Just created a 2nd model, named clip rev2, follows the original clip very closely, but it aint perfect. It will also have to be resized!
| cable_clip_1.stl | 829.0KB | |
| clip_rev2.stl | 518.8KB |
