Laser cut door pull / button pusher / switch flipper with a sheath. Use to avoid skin contact with different surfaces. This is a design remixed from a 3d print by DiAleksi.
The Touch-inator and sheath spine are cut from 1/4" plywood and the sheath sides are cut from 1/8" plywood. Sand the Touch-inator down by 0.5-0.8 mm on one side to accommodate finish thickness and make for an easier fit in the sheath. Magnets are embedded in the side of the sheath and the Touch-inator for a magnet catch. A belt clip was made from 0.08" (2mm) acrylic that was heat formed.
Build Log: https://forum.makerforums.info/t/touch-inator-2020/80016
| Touch-inator_2020.svg | 44.1KB |
