Novinka:
Na přání jsem přidal nový soubor (Totem_S_Air_assist_ZD_tube_8-6) s upravenou trubičkou na hadičku s vnitřním průměrem 6mm
News:
On request I added a new file (Totem_S_Air_assist_ZD_tube_8-6) with a modified tube for a tube with an internal diameter of 6mm
CZ
Navrhnul jsem air assist na Totem S 40W se zaměřováním.
K montáži budete muset do těla diody vyřezat závit 4xM3. Díry by tam už měly být, takže je nemusíte vrtat.
Dále hadičku s vnitřním průměrem 4mm.
Na straně, která bude doléhat na tělo diody jsem udělal zápich na O-kroužek (8x2mm) ,aby vrchem neutíkal vzduch. Ale po odzkoušení jsem zjistil, že O-kroužek není nutné dávat a funguje to dobře i bez něj.
Vytvořil jsem i FB stránku zaměřenou na Totem S.
Pokud máte zájem o podporu stránky, pomáhat ostatním s problémy či vyřešit svůj problém budu rád když se přidáte :)
Laser Totem S (CZ/SK):
https://www.facebook.com/groups/949329186016806
EN
I designed the air assist on the Totem S 40W with targeting.
To assemble, you will need to carve a 4xM3 thread into the body of the diode. The holes should be there by now, so you don't have to drill.
Next, a tube with an internal diameter of 4mm.
On the side that will reach the body of the diode, I made an O-ring (8x2mm) to keep the air from running through the top. But after testing, I found that the O-ring is not necessary to give, and it works well without it.
Totem_S_Air_assist_ZD_tube_6-4.stl | 190.1KB | |
Totem_S_Air_assist_ZD_tube_8-6.stl | 196.4KB |