Torrot (Volcon) – MX1 & MX2 Throttle Spacer 3D Printer Model
The file 'Torrot (Volcon) – MX1 & MX2 Throttle Spacer 3D Printer Model' is (stl) file type, size is 51.1KB.
The file 'Torrot (Volcon) – MX1 & MX2 Throttle Spacer 3D Printer Model' is (stl) file type, size is 51.1KB.
This is a modification to take the large amount of free play out of the throttle. You may need different sizes depending on the bike. Below are the sizes that worked for my kids bikes. Below are the ones I used to set the gap to 2mm before the motor engages.
MX1- 6mm
MX2- 5.5mm
Important!!!
If you use too large of a spacer then the bike won't allow you to engage the motor. This is a good safety measure!
Here is the link to install.
https://youtu.be/sMS4gWVMVw8
I take no responsibility for failures, injuries or death. Installing this part is at your own risk. Printed parts can fail which can result in a stuck throttle.
| Thorttle-_5.5mm-_Final.stl | 42.0KB | |
| Throttle-_4.5mm-_Final.stl | 25.8KB | |
| Throttle-_4mm-_Final.stl | 6.4KB | |
| Throttle-_5mm_-_Final.stl | 28.1KB | |
| Throttle-_6mm_-_Final.stl | 41.4KB | |
| Throttle._6.5_Final.stl | 55.6KB | |
| Throttle_-_Final_7mm.stl | 11.7KB |
