Holders for 2s balance leads (XH2.54 3 pin plugs) so that i can insert/remove them from the Toothstor charger easily. This is used to make 2s balance leads so that each Toothstor port charges 2 x 1S batteries (instead of the normal 1x 2S battery). Using these i can charge up to 8 x 1S batteries at a time... but also remove these balance leads easily to charge 2s batteries.
Is it necessary? Not really, but it is just a little bit easier to use, and removes wear and tear on the wires
Print in TPU, 100% infill, no supports. 2s lead push fits in there and then leads are pushed through the holes on the side. Solder the BT connections to the leads after pushing the plug through the print.
| 2S_connector_holders_2.stl | 105.4KB |
![Knifey [Toy Story] 3D Printer Model](https://cdn.3axis.co/assets/fb/32/6e/80/fb326e80-7e1a-4646-a4b9-22c62237b718/images/b45604ac-2887-4383-9a78-b2b3a2a2b28c_thumb.jpg)
