Easy to print suitable for 1/43 scale car
Tools for garage O scale 1/43:garage lift-car, crack, garage winch and more.....
Garage winch in 2 parts. Place vertical and glue. Make a crank for the engine lift and add a rope and a hook
For the garage lift you have to print twice the piers. Note they are different. Display one with switches on each side.
Pass 2 iron rods through the lift and on each side it comes to the piers. Glue in place.
Either the garage lift is up, use the flaps down, and if lift is down the flat flaps. Glue the flaps.
The rolling jack: make a handle with iron rob.
| 2xPiersLift143.stl | 101.3KB | |
| BaseLift.stl | 35.8KB | |
| compressor.stl | 334.5KB | |
| Draws.stl | 20.5KB | |
| FlapsLiftGarage.stl | 61.2KB | |
| lift-engine.stl | 273.8KB | |
| LiftGarage143.stl | 47.5KB | |
| LiftGarage143Vers2.stl | 46.3KB | |
| RolingCrick.stl | 65.6KB | |
| Shelves.stl | 5.4KB | |
| ToolBox.stl | 67.2KB | |
| Welding.stl | 589.4KB |
