The 2 square supports or feet on the front are to make printing easier. I found trying to print without them was sometimes difficult. Cut them off once printing is complete. This is a tool holder for lathe back splash. It fits the LMS 7500 mini lathe. The guard is 1.90 inches. You can design an insert to reduce the fit that will slip into the 1.9inch slot to fit your lathe back splash.
Lathe Guard Catch All No Support Feet.stl saves 1 hour print time when printing on it's side, however the tops look better using a bed slinger.
| Lathe_Guard_Catch_All_2.stl | 704.8KB | |
| Lathe_Guard_Catch_All_No_Support_Feet.stl | 701.7KB |
