This is my 3D printer, it's still a work in progress, but I have succesfully got it printing pretty well! Please get in touch if you would like STEP files for anything, there are areas of the build I am not entirely happy with currently but it's been a great success for me so far.
The build volume is 215x15x~300mm but is totally customizable depending on extrusion used. I have used the bed from my reprap i3 and the end stops (end stop mounting is one area that still needs some work.
Also needed is:
20x20extrusion in the following lengths:
525mm x 2
455mm x2
410mm x 2
290mm x 4
250mm x 2
50mm x 2
10mm rods cut to:
290mm x 2
430mm x2
415mm x2
2x 415mm lead screws
4x 16 tooth gt2 pulleys
10x LM10UU bearings
4 x 5x8x3mm (or similar width) bearings
Selection of m3 and m5 nuts and bolts, I will update with lengths at some point but its not a huge list.
m5 channel nuts for the extrusion
angle brackets for the extrusion, I think I got 50 and it was enough.
Further updates to come, comments and modification is greatly welcomed.
| bed_packer.STL | 16.5KB | |
| Display_wedge_v1.STL | 155.2KB | |
| Nema_17_holder_y_axis.STL | 77.9KB | |
| Nema_17_holder_z_axis_left.STL | 79.0KB | |
| Nema_17_holder_z_axis_right.STL | 79.0KB | |
| Ramps_fan_holder.STL | 51.3KB | |
| Upper_Z_support.STL | 46.4KB | |
| x_axis_end_stop_proto.STL | 94.3KB | |
| x_axis_motor_side.STL | 296.3KB | |
| x_axis_non_motor_side.STL | 362.6KB | |
| X_carraige_clamp.STL | 135.5KB | |
| X_carriage.STL | 239.7KB | |
| Y_axis_Slide_supports.STL | 76.3KB | |
| y_end_stop_proto.STL | 34.0KB | |
| Y_tensioner_base.STL | 96.8KB | |
| Y_tensioner_top.STL | 126.9KB | |
| Z_end_stop_proto.STL | 44.8KB |
![[WIP] – SW X-WING THE MINIATURE GAME MANEUVER DIAL – REBEL ALLIANCE 3D Printer Model](https://cdn.3axis.co/assets/43/d2/2b/5a/43d22b5a-66be-40a0-891b-a1019b6fa854/images/554621e6-69c0-46f3-bb9f-77c728e97053_thumb.jpg)
