(revision B of Toilet seat lateral movement stopper added. Holes made slightly larger)
(Image used of blocks fitted to seat are my other design. This design is the same principle but a smaller form factor)
Using two of these blocks fixed to the underside of your toilet seat (the ring part) will reduce lateral movement that attributes to the loosening of the fixings and eventual failure. Image attached is for reference only and is off original design.
New design allows you to adjust the position to the toilet bowl a lot easier. Also depending on the integrated blocks on your toilet seat, you may need to use the spacers to adjust the height.
Dimensions
Base of block is L 40x18mm
height of block is 26mm with option to increase by 5mm and 10mm blocks.
Hole dimensions are 3.5 pilot hole (can be made slightly bigger with drill if needed)
Print solid for strength
Any issue, please message me.
| Toilet_seat_Lateral_movement_stopper_v2_REVB.stl | 45.0KB | |
| Toilet_Seat_Lateral_Movement_V2_10mm_extender.stl | 20.8KB | |
| Toilet_Seat_Lateral_Movement_V2_5mm_extender.stl | 20.8KB |
