The original design was great, but printing as one piece left rough edges where the bridges had been. Knowing my wife would consider that unhygenic I redesigned so that all surfaces near the toilet will be perfectly smooth (align pin sides up when printing).
My distance between pins was a little different than the original so I moved them. If you need to do the same, do so by moving the half pin. That way your full pin and through-hole will still align.
Print 2 of each piece, I used PLA. Put a little Loctite Superglue gel on the bottom half piece on each side of the pin and then insert through the upper piece so that both pins are facing up. You may want to dry fit them first before adding glue.
| ToiletSeatRest.skp | 1.3MB | |
| ToiletSeatRest.stl | 119.3KB |
