Toilet Bolt Part Deux 3D Printer Model
The file 'Toilet Bolt Part Deux 3D Printer Model' is (stl) file type, size is 502.8KB.
The file 'Toilet Bolt Part Deux 3D Printer Model' is (stl) file type, size is 502.8KB.
I needed a bolt and nut to fix my toilet seat and while there are several bolts available here some were not the correct size and others required supports that in some cases difficult to remove. This is design in three parts with no supports required or glueing. There is a bolt, a washer, and a wing nut. The washer may be a bit tight on the bolt but that was by design. A little cleaning of the inside perimeter should help the washer slide onto the bolt. The bolt has a 1/2 inch (12.9 mm) hex head, is approximately 1.7 inches (44 mm) long, and .35 inches (8.5 mm) in diameter.
| Bolt.stl | 826.9KB | |
| Nut.stl | 529.4KB | |
| Washer.stl | 34.5KB |
