Hello Everyone! This is version 2.0 of the toaster shaped sponge holder, a fun way to hold your sponges and keep them off of the still water on the counter! Recently added slots to make it fully breathable. There are two seperate prints: one for the toaster body and one for the legs. I super glued the legs on the corner. May add another stl that is a complete assembly if requested.
Print with the bottom down on the bed.
Disclaimer: I am not an expert when it comes to mold and bacteria. What I did to help prevent this issue was put a coat of polyurthane on the print to try my best to seal it.
| Toaster-2.0.STL | 11.9MB | |
| Toaster_Leg.STL | 173.3KB |
